COMPANY NEWS

Introduction to the use of spray polyferric sulfate

When many users came into contact with polyferric sulfate in the early days, they still used liquid polyferric sulfate. In recent years, with the continuous improvement of water purification products, they produced spray polymerized aluminum chloride, because the liquid polyferric sulfate is not convenient to transport far away. Then, after many experiments, they produced spray polyferric sulfate, which is convenient to transport, convenient to use, moderate in price, remarkable in effect, and has been widely praised by customers, How about the effect of spray polyferric sulfate?

Spray polyferric sulfate is a high molecular inorganic flocculant. The aluminum chloride produced by the pressure spray process is porous small particles or hollow small particles, showing dustproof and smoothness. Due to its better contact with the water to be treated, its wettability and water treatment speed are stronger than other powdered products. Polymeric ferric sulfate is a water-soluble substance and shows good thermal stability and solubility.

The color of spray type polyferric sulfate is yellow powder, which is slightly different from that of spray type polymerized aluminum chloride. The yellow of spray type polyferric sulfate is heavier, and the morphology is fine powder, which is very soluble in water. The dissolution method of spray type polyferric sulfate is: put polyferric sulfate into the alum dissolving tank at a certain concentration (10-30), add tap water to stir it to fully dissolve, and let it stand until it is reddish brown liquid, Add coagulation after diluting with water to the required concentration. The water plant can also be directly added into 2-5, and the industrial wastewater treatment can be directly added into 5-10.

The dosage of spray polyferric sulfate can be determined by the production commissioning or beaker test results according to the nature of the source water. Generally, 5-6 beakers are prepared to take the same source water and add different concentrations of polyferric sulfate. In this way, the effect is obvious, and the good points with good effect and small dosage are selected for dosing.

When using spray polyferric sulfate, pump the above prepared liquid into the metering tank and coagulate with the source water through metering.

The liquid prepared by spray polyferric sulfate should be prepared and used on the same day. The water for dispensing needs tap water, and the slight sediment needs to be normal.

Pay attention to the hydraulic conditions of the three stages of the coagulation process and the formation of alum Flos in spray polyferric sulfate.

Spray polyferric sulfate enhanced filtration is mainly to reasonably select the filter layer structure and filter aid to improve the removal rate of the filter, which is an important measure to improve water quality.

Spray type polyferric sulfate is applied to the treatment of environmental protection and industrial wastewater. The use method is roughly the same as that of water plants. It has a good effect on the treatment of source water with high chromaticity, high COD, BOD, and auxiliary agents. Especially for high phosphorus water, the use effect of spray polyferric sulfate is particularly obvious.

The form of spray type polyferric sulfate is dry and fine powder, which is easy to absorb moisture. It must be stored in a dry, moisture-proof and heat-resistant place. It is forbidden to store it together with other chemicals and alkaline items. The product can be stored for a long time when the package is intact.

Thank you for your attentionHenan aierfuke Chemical Co., Ltd：Focus on water treatment, only for the healthy world! Our company is committed toPolyaluminium chloride、Polyferric sulfateThe R & D, manufacturing and sales of series of water purification materials are willing to create success with our customers and friends.